● Channels: 16 single-ended or 8 differential, switch selectable.

● Resolution: 12 binary bits.

● Accuracy: 0.1%.

● Input Voltage Modes: ±5V, ±10V, 0-10V

● Input Amplifier Gains: 1, 10, 100, 1000 (Under software control per channel).

● Coding: True binary for unipolar inputs and offset binary for bipolar inputs under jumper control.

● Conversion Time: 8 usec max. (100 KHz throughput)

● A/D Type: Successive Approximation.

● Monotonicity: Guaranteed over operating temperature range.

● Linearity: ±0.9 LSB.

● Zero Drift: ±2 PPM/°C.

● Gain Drift: ±2 PPM/°C.

● Trigger Source: Software Command, On-board Programmable Timer, or External Source.

● Channels: Two, independent.

● Type: 12-bit, double-buffered.

● Relative Accuracy: ±1 LSB.

● Output Ranges: 0-2.5V, 0-5V, 0-10V, +2.5V, ±5V, ±10V.

● Settling Time: 15 usec to ± 1 bit.

● Output Drive: 5 mA.

● Output Impedance: 0.5 ohms.

● Inputs

- Logic High: 2.0 to 5.0 VDC at 20 uA max.

- Logic Low: -0.5 to 0.8 VDC at -0.2 mA max.

● Outputs (DIO 0 thru DIO 7)

- Logic High: 2.4V minimum at 0.4 mA source.

- Logic Low: 0.5 V maximum at 8.0 mA sink.

● Inputs

- Logic High: 2.0 to 5.0 VDC at +10 uA max.

- Logic Low: -0.5 to +0.8 VDC at -10 uA max.

● Outputs (DIO 0 thru DIO 7)

- Logic High: 2.5 VDC min. at 200 uA source.

- Logic Low: 0.5 VDC max. at 1.7 mA sink.

● Type: 82C54-2 programmable interval timer.

● Counters: Three 16-bit down counters, two concatenated with 1 MHz clock as programmable timer. One counter may be driven by an external input to 10 MHz or driven by internal 1 MHz clock source.

● Output Drive: 2.2 mA at 0.45V (5 LSTTL loads).

● Input Gate: TTL/DTL/CMOS compatible.

● Clock Input Frequency: DC to 10 MHz.

● Active Count Edge: Negative edge.

● Minimum Clock Pulse Width: 30 nS high/50 nS low.

● Timer Range: 2.5 MHz to < 1 pulse per hour.

● Operating Temperature Range: 0° to 60°C.

● Storage Temperature Range: -40° to +100°C.

● Humidity: 0 to 90% RH, non-condensing.

● Size: 9.0 inches long (229mm)

● Weight: 10 oz.

● Power Required: +5 VDC, 800 mA.

● This product is designed to be in full compliance with CE requirements.